Thermostat and Water Pump (MQB 1.8t and 2.0t) w/ Install Kit

If you are unsure about fitment for your vehicle, send us an email with your VIN. Some vehicles may require a different pump.

Thermostat and Water pump Assemblies are the most common issue on MQB 1.8t and 2.0t engines.  The most common symptom of a bad thermostat assembly would be low coolant level.  As this unit is leaking we would expect you to get low coolant warning lights on your dash.  Generally when these units leak it will be slow at first, then get worse over time.  

The easiest way to determine if your water pump / thermostat housing is leaking is to inspect under your vehicle.  This part is located at the front of the engine, centered from left to right.  If you have a small puddle under the front of your engine, and you vehicle is listed on the application data below, this part is the most likely cause.  

We do have a DIY video that shows you how to replace this part which will be linked below.  

To be used for part numbers

06L121111P, 06L121111M, 06L121012L, 06L121012K, 06L121012H, 06L121012A, 06K121011C, 06K121011B, 06K121011

MQB 1.8t and 2.0t Thermostat and Install Kit Includes

Thermostat with Housing - INA

Water Pump w/ Gasket - INA

Water Pump Belt - INA

Belt Drive Gear Bolt (Reverse Thread) - INA

Union Pipe (Thermostat to Oil Cooler) - Genuine VW/Audi

Concentrated Coolant - 4 Liters - Genuine VW/Audi

Intake Manifold Gasket - Genuine VW/Audi

Tools for Installing this Thermostat Housing

Sockets - 7mm, 10mm, 13mm, 24mm, 32mm

Torx Bits - T25, T30

Wrenches - 13mm, 17mm(Stubby), 21mm

Flat Head Screw Driver

90 Degree Pick

Extensions

How to Install this MQB/MK7 Thermostat Housing